There are following steps to install the Nginx on Mac OS: Mac Install Nginx Without Homebrew Mac Php Fpm Nginx Nginx Download Mac Os Mac Nginx Config Homebrew When it comes to developing locally, there are many options for Mac users, including the dummy way of MAMP and XAMPP. However, for those who wants a. Bitnami NGINX Open Source Stack Virtual Machines. Bitnami Virtual Machines contain a minimal Linux operating system with NGINX Open Source installed and configured. Using the Bitnami Virtual Machine image requires hypervisor software such as VMware Player or VirtualBox. Both of these hypervisors are available free of charge. Most admins will want to make sure that NGINX starts up automatically whenever the server restarts. To set this up, run: sudo systemctl enable nginx Step 6: Configure Firewall to Allow Traffic. CentOS 7 enables firewalls by default and blocks access to ports 80 and 443. It will block any inbound HTTPS and HTTP packets from Nginx. Download and install. Installing as a Linux package Building from the sources: Installing as a Linux package. For Linux, njs modules packages can be used: nginx-module-njs — njs dynamic modules nginx-module-njs-dbg — debug symbols for the nginx-module-njs package.

Installing as a Linux package. For Linux, njs modules packages can be used: nginx-module-njs — njs dynamic modules. Nginx-module-njs-dbg — debug symbols for the nginx-module-njs package. After package installation, njs dynamic modules need to be loaded with the loadmodule directive: loadmodule modules/ngxhttpjsmodule.so.

Heavily borrowed from: Nginx configuration for Mac OS X with Homebrew, using sites-enabled directory.

Install nginx

For enabling a site:

Start nginx:

Update /etc/hosts file:

My site config file:

My nginx.conf

UPDATES:

Despite following the above instructions, I was again caught with error issues while setting up my new Catalina OS.

The resolution steps after troubleshooting the problems were:

Make sure the last line in the above nginx.conf is updated to:

Note ... then *.*

Next, this was a REAL issue, I did everything perfectly but STILL the enabled was not getting picked up!!!

As mentioned here (https://stackoverflow.com/a/53528685), I needed to add listen [::]:80;to bind the site to IPv6 and my PC was on an IPv6 connection

Below is the exact site config:

Nginx Mac Address

Nginx Status On Mac

Also, not to forget .. my /etc/hosts/ file is: